|
|
Maintenance
Cultured Marble
| Hydro Jet Whirlpools
Cultured Marble
Cultured Marble, if properly cared
for, will last for the life of your home. Some helpful hints
about the proper maintenance of your cultured marble products are
provided below:
Do's:
-
Clean your cultured marble with mild, non-abrasive
window cleaner such as Windex or 409.
-
A high gloss finish can be attained by
using a car wax, a fiberglass boat wax, or a good furniture
polish.
-
If your cultured marble product is accidentally
damaged please call our office for service and we will be happy
to assist you.
Don'ts:
-
Do not clean your cultured marble with any
abrasive products such as Soft Scrub, Ajax, Zud, Comet, etc.
-
Do not attempt to remove any dried-on materials
such as paint, glue, or grease using sharp objects.
-
Do not clean the surface with nail polish remover
or any other chemical containing acetone.
-
Do not place hot objects such as pans, curling
irons, or clothing irons directly on the surface of the marble.
Back to the Top
Hydro Jet Whirlpool
Maintenance
-
Before turning the pump on, ensure that the
water level is at least two (2) inches above the highest jet.
Early activation can cause the pump to burn out and invalidate
the warranty.
-
When adding substances that produce bubbles,
use only half the amount recommended on the package. The
action of the jets will increase the number of bubbles.
-
We recommend cleaning the the plumbing of the
whirlpool every six (6) to twelve (12) months to remove any
accumulated soaps and oils. To do this: Fill the
tub with hot water and add four (4) scoops of a dish washing
detergent such as "Cascade". Run the whirlpool
for 30 minutes. Drain the tub refilling it with cold water,
and run the jets for 20 minutes. Drain again and enjoy
your whirlpool for another year!
Back to the Top
|
|
